tag:blogger.com,1999:blog-36913768.post1789294382402360752..comments2024-03-28T23:08:14.827-07:00Comments on Unreasonable Rocket: Tanks, good news bad news...Paul Breedhttp://www.blogger.com/profile/11024641086551653462noreply@blogger.comBlogger5125tag:blogger.com,1999:blog-36913768.post-59825557596419290052020-06-10T10:29:21.758-07:002020-06-10T10:29:21.758-07:00Thank you for posting this amazing post and trick,...Thank you for posting this amazing post and trick, keep continue writing these amazing tricky informative blog.<a href="https://www.budapest23.com/" rel="nofollow">Budapest Rentals</a>John Smithhttps://www.blogger.com/profile/09269244386363714892noreply@blogger.comtag:blogger.com,1999:blog-36913768.post-7824108920133521672007-11-13T07:13:00.000-08:002007-11-13T07:13:00.000-08:00We did that with one tank and it failed at 425 PSI...We did that with one tank and it failed at 425 PSI.<BR/>But it looks like an obvious welding flaw.Paul Breedhttps://www.blogger.com/profile/11024641086551653462noreply@blogger.comtag:blogger.com,1999:blog-36913768.post-19348414146940630962007-11-13T05:50:00.000-08:002007-11-13T05:50:00.000-08:00Then what about just placing them in a furnace to ...Then what about just placing them in a furnace to stress relieve them and let them cool slowly? I'm no heat treating expert, but could welding cause thermal induced stresses? Would your welder know?<BR/><BR/>--- Carl T.Carl Tedescohttps://www.blogger.com/profile/06410117998639382093noreply@blogger.comtag:blogger.com,1999:blog-36913768.post-43017386530368614792007-11-12T22:44:00.000-08:002007-11-12T22:44:00.000-08:00They cant heat treat closed tanks.They can't quenc...They cant heat treat closed tanks.<BR/>They can't quench the tanks without colapsing or blowing them up.<BR/><BR/>6063-T6<BR/><BR/>PaulPaul Breedhttps://www.blogger.com/profile/11024641086551653462noreply@blogger.comtag:blogger.com,1999:blog-36913768.post-78844827793181443132007-11-12T22:10:00.000-08:002007-11-12T22:10:00.000-08:00Paul,What alloy are your tanks again? Is there any...Paul,<BR/>What alloy are your tanks again? Is there any temper? If they are tempered, say T6, the heat from welding has to be affecting it and thus weaken the area. The company I sent you to for the brazing also does heat treating. So does a company called Bodycote in Mira Mesa.<BR/>--- Carl T.Carl Tedescohttps://www.blogger.com/profile/06410117998639382093noreply@blogger.com